Section 75 of 104
73. Contractor and Installer Participation
Stable section ID: S05-CON-016-SECTION-75 · 18 content blocks
Contractors and installers shall be qualified for the System05 tasks they perform and shall work from controlled configurations and instructions.
Participation requirements may include:
system orientation and safety training;
Product and identity recognition;
tool and equipment competence;
tolerance and alignment procedures;
temporary stability and bracing;
locking and state confirmation;
inspection checkpoints;
digital record updates;
Nonconformity reporting;
repair and recovery limitations.
Installers shall not substitute Products, alter Cartridges, modify Interfaces, or bypass required checks without documented authorization.
The system should make correct installation clear and incorrect installation difficult or detectable through physical keying, markings, measurement, sensing, and Compiler-generated instructions.
Field conditions that prevent conforming installation shall be escalated rather than concealed through improvised correction.
- Installer qualification shall be scoped by Product family, Building type, task, equipment, and maturity level.
- Installation Evidence shall identify who performed and verified consequential operations.
Feedback from contractors shall be incorporated into design improvement, especially where repeated problems reveal inadequate access, unclear instructions, excessive tolerance sensitivity, or unsafe sequencing.