Section 47 of 104
45. Reference Interface Specimen Program
Stable section ID: S05-CON-016-SECTION-47 · 16 content blocks
The Reference Interface Specimen Program shall provide physical and digital artifacts through which System05 Interface definitions can be measured, tested, demonstrated, and independently implemented.
Reference Interface artifacts may include:
geometric master gauges;
datum and alignment specimens;
go/no-go gauges;
locking and retention test rigs;
load-transfer fixtures;
robotic approach and grasping models;
identity and data-exchange test packages;
simulated damaged or incompatible Interfaces;
- software Interface conformance datasets.
- Each artifact shall be traceable to an exact Interface Specification and Version.
The Program shall test complete Interface behavior, including geometry, tolerances, capacity, permitted states, locking confirmation, environmental boundaries, inspection, release, data exchange, and failure behavior.
Interface specimens should allow independent manufacturers to determine whether their Nodes, Cartridges, tools, Robots, or software can participate without access to proprietary internal Product designs.
Physical fit shall be evaluated together with functional Compatibility. A specimen that can be inserted but cannot safely transfer required loads or confirm its locked state shall not pass Interface testing.
Reference artifacts shall be recalibrated, replaced, or withdrawn when damage, wear, Specification changes, or measurement uncertainty invalidate their use.