Implementation Roadmap

The Minimum Interface Set shall define the controlled boundaries required for the first integrated System05 implementation.

The Interface Set should include:

structural load-transfer Interface;

geometric alignment and datum Interface;

locking and retention Interface;

handling and robotic-access Interface;

inspection and condition-verification Interface;

physical identity Interface;

sensor and Smart Module data Interface;

utility or protected-routing Interface where included;

software and Registry Interface;

lifecycle release and replacement Interface.

Each Interface shall define:

participating entities;

geometry and tolerances;

loads, states, and environmental conditions;

directionality and permitted actions;

Compatibility and Version rules;

inspection and acceptance criteria;

failure and safe-state behavior;

required Evidence;

The minimum Interface architecture shall support capability negotiation or controlled compatibility lookup before assembly, replacement, or automated action.

Physical keying, digital validation, procedural controls, or a combination of these methods should prevent foreseeable incompatible assembly.

The Interface Set shall remain small enough to implement and verify but sufficiently complete to demonstrate future interoperability among independent manufacturers.